# Podcast editing practice

Edit a short two-person interview with a WAV-capable audio editor. Keep the original stereo file and export a mono WAV for review. Allow about 15 minutes.

## Edit the interview

1. Import `podcast-interview-source.wav`. Listen once and identify the setup taps near the beginning and the long pause after the first question.
2. Listen to each channel on its own. The interviewer is on the left and the other speaker is on the right. Keep both speakers in the edit.
3. Remove the setup and shorten the pause. The cut sheet in this folder gives both ranges in the original file. Make the later cut first if the editor shifts audio after a deletion.
4. Export a mono, 48 kHz, 16-bit PCM WAV. Mix each channel at half gain. Leave automatic normalization off when comparing against the worked answer.
5. Reopen your export. Check the cut into the first reply and the two voices talking at the same time near 7.5 seconds in the answer. Check both the timing and that all four lines are audible.

## Check your result

The source is 15.5 seconds. The two cuts remove 3.5 seconds in all, leaving 12 seconds. `podcast-interview-answer.wav` gives one worked edit. It mixes both channels equally and preserves the overlapping dialogue. Small sample differences can arise if your editor applies dither or rounds differently. A listening check also matters.

The times below refer to the mono answer. The interviewer is on the left in the stereo source and the guest is on the right.

- Interviewer at 0.6 seconds · “Which take should we check first?”
- Guest at 3.4 seconds · “Start with the take near the window.”
- Interviewer at 6.8 seconds · “I will mark the beginning of the clip.”
- Guest at 7.5 seconds · “I will listen for the final word.”

For a class, collect the exported WAV and two short notes. Ask the learner which source channel carries each speaker and why exporting only one of them loses part of the interview.

## About the audio

The four scripted lines were generated with eSpeak NG for the SaturaLabs stereo interview exercise. The raw practice file adds two synthesized taps and a silent interval. The manifest gives the exact format, length, and SHA-256 for each supplied WAV. The source contains no recorded interview participant.

[Open the lesson and individual audio files on SaturaLabs](https://www.saturalabs.com/audio-workflow-kits/podcast-editing-practice?utm_source=podcast_editing_zip&utm_medium=referral&utm_campaign=podcast_practice)
