saturalabs

Audio Drifting Out of Sync? Compare Offset and Drift With Two Claps

A late first clap does not tell you whether the same shift will fix the end. Compare two flashes in a 14-second video with three WAVs that have exact sample positions. The pair of claps reveals whether the error stays fixed or grows.

Watch the two-clap sync test

Watch each square brighten, then listen for its clap. The two flashes stay 12 seconds apart in every example.

ExampleFirst clapSecond clap
0:00 · AlignedIn syncIn sync
0:14 · Fixed delay120 ms late120 ms late
0:28 · Increasing drift120 ms late320 ms late

Download the comparison video · Download its English captions

Downloads

Listen to the files

Run the two-point check

  1. Place the picture reference and one WAV at the same timeline start. Mute the MP4’s own audio to avoid doubling.
  2. Measure each clap against its picture flash. Compare the errors. In the fixed-offset version, move the WAV 120 ms earlier and check both flashes again.
  3. In the drift version, moving the WAV 120 ms earlier fixes the first flash and leaves the second 200 ms late. Inspect duration, frame-rate interpretation, and the original recording clock before altering speed.
  4. After any correction, compare the beginning, end, and a point in the middle. Export a short proof and play the export back.

How to read the result

The WAV event positions are measured in samples. The picture flashes begin on frames 30 and 390. At 30 frames per second, frame-level placement is coarser than individual WAV samples.

This exercise creates increasing drift by moving the second clap. Real recordings can have variable frame rates, dropped sections, changing delays, or independent device clocks.

Continue the workflow