saturalabs

Four Tested FFmpeg Recipes for Video Audio and Channel Splitting

Run these commands with known input files, then compare your outputs with the recorded codec, sample rate and duration. The left and right WAVs from the tested channel-split command matched the reference samples exactly.

Downloads

Decode the first audio stream of a video to WAV

Use two-clap-reference.mp4 from the sync kit. The tested output was mono 16-bit PCM at 48 kHz. The decoder retained 16 ms of AAC padding past the 14-second picture. If your input has multiple audio streams, inspect the file and select the intended one.

ffmpeg -i two-clap-reference.mp4 -map 0:a:0 -vn -ar 48000 -c:a pcm_s16le soundtrack.wav

Copy an AAC stream into M4A

Use the same MP4. This command keeps the AAC encode intact. Confirm the input codec is supported in the output container when using your own file.

ffmpeg -i two-clap-reference.mp4 -map 0:a:0 -vn -c:a copy original-audio.m4a

Split a stereo interview into mono channels

Use interview-stereo.wav from the interview kit. Each tested output kept the full 12 seconds and matched its corresponding mono reference sample-for-sample.

ffmpeg -i interview-stereo.wav -filter_complex '[0:a]channelsplit=channel_layout=stereo[left][right]' -map '[left]' -c:a pcm_s16le left.wav -map '[right]' -c:a pcm_s16le right.wav

Cut an excerpt and reduce its low frequencies

Use steady-hum-original.wav from the listening study. The tested command produced a two-second mono WAV. Listen to the change in wanted speech along with the change in the hum.

ffmpeg -ss 1 -i steady-hum-original.wav -t 2 -af 'highpass=f=100' -c:a pcm_s16le high-pass.wav

Inspect what was written

Replace soundtrack.wav with the output you want to inspect. The JSON download shows the results observed from these fixtures.

ffprobe -v error -show_entries stream=codec_name,sample_rate,channels,duration -of json soundtrack.wav

Continue the workflow